Tight AV Dante 2 Channel XLR Output Adaptor

Description

This is a plug-and-play PoE Dante interface which outputs two channels of analog line level audio from your Dante network. It supports sample rates up to 96kHz, using Audinate’s original Dante Ultimo chip. Featuring two male XLR standard connectors, the AU-X2O-DA is a simple and cost-efficient solution to connect analog equipment to a Dante network. PoE support allows for a simplified installation via a PoE-capable network switch or from a separate PoE injector.

• Plug and Play
• 2 x line outputs on standard XLR male connectors
• Dante and AES67 support
• 24-bit audio support
• Supports 802.3af PoE
• Dante Controller and Dante Domain Manager compatible =+= Technical Specification
AUDIO
Max signal level
+18 dBu / +4 dBu / 0 dBu 0 dBV /-10 dBV
Frequency Response
20 Hz to 20 kHz (-/+0.5dB)
Impedance
150 Ohm balanced 75 Ohm unbalanced
Dynamic Range
>100 dB
Signal to Noise Ratio
>100 dB
THD
<0.01% @+4 dBu DANTE Sample Rate 44.1 kHz, 48 kHz, 96 kHz Bit Depth 24 Dante Device Latency 1, 2 or 5 ms (configurable using Dante Controller) Network Transport Dante Audio over IP AES67 RTP GENERAL Connectors 2 XLR-M Operation Temperature -5 to +55 (+23° to +131°F) Storage Temperature -25 to +70℃ (-13° to +158°F) Power 802.3af PoE Power Consumption 2.6W (Max) Dimension (W*H*D) 30 x 28 x 114 mm Cable length 300mm Net Weight 145g